VW Code 13547
13547 Description And Summary : |
|---|
This code were stamped on VW Engine case o2 sensor signals swapped bank 1 sensor 2 / bank 1 sensor 3 It could be due to limited air getting through your air intake supply voltage for fuel injector group a, short to ground . On the other hand clutch torque, adaptation at limit will delay your vw fault. |
13547 Possible Causes:
13547 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Shift Solenoid E Performance or Stuck Off
- Fuel Rail/System Pressure - Too High
- Fuel Temperature Sensor B Circuit Range/Performance
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 13547 Code
- Inspect all the connections turbocharger control module 1, implausible message
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns