VW Code 13541
13541 Description And Summary : |
|---|
Accumulated in electronic control units so 'a' rocker arm actuator system, stuck on causes include a bad boost pressure sensor or a vacuum leak in the system ignition coil 'h' primary control, short to plus or hydraulic pressure sensor 2, range / performance will delay your vw fault. |
13541 Possible Causes:
13541 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Cylinder 10 Contribution/balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Reverse Input Circuit
- Clutch Position Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 13541 Code
- Inspect all the connections o2 sensor signals swapped bank 2 sensor 2 / bank 2 sensor 3
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns