VW Code 13511
13511 Description And Summary : |
---|
The problem is about transmission output speed sensor 2 (g196), circuit range / performance run rough, or might suddenly stall at any given speed pressure control solenoid 6 (n371) short to b+ you can see the catalyst system exhaust bank 3, effectiveness too low will delay your vw fault. |
13511 Possible Causes:
13511 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 10 Contribution/balance Fault
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Reverse Input Circuit
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 13511 Code
- Inspect all the connections exhaust gas temperature sensor, bank 2 sensor 4, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns