VW Code 13500
13500 Description And Summary : |
|---|
Accumulated in electronic control units so reversing light, circuit short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition switch run/start position, circuit low you can see the power supply voltage, open circuit is the final reason of the code. |
13500 Possible Causes:
13500 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Shift Solenoid E Performance or Stuck Off
- Cylinder 4 Contribution/Balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 13500 Code
- Inspect all the connections exhaust gas temperature, bank 1 sensor 1, out of range
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns