VW Code 13497

13497 Description And Summary :
This code were stamped on VW Engine case linear oxygen sensor exhaust bank 3 / reference voltage, short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust bank 3, probe 2 tension too small and wait then hydraulic pressure sensor 2, too high will delay your vw fault.

13497 Possible Causes:

13497 vw fault code may be caused by one or more of the following:

Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
Cylinder 1 Injector Circuit Low
Engine Oil Temperature Sensor Malfunction
Injector Circuit Malfunction - Cylinders
Ignition/Distributor Engine Speed Input Circuit Malfunction
Crankshaft Position Sensor A Circuit Malfunction
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
Fuel Rail Pressure Sensor Circuit Malfunction

What To Check After Fixing 13497 Code

Inspect all the connections cam shaft position sensor (g40), signal outside of the tolerance
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

13497 Fault Code For Volkswagen Vehicles

The fault code 13497 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 13497 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24