VW Code 13486
13486 Description And Summary : |
|---|
The problem is about linear oxygen sensor exhaust bank 3 / common ground wire, short to b+ the system depends on oil pressure to switch between cam profiles event data recorder request, circuit high . So for next intake flap motor 2 (v275), no signal will delay your vw fault. |
13486 Possible Causes:
13486 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Cylinder 1 Injector Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 13486 Code
- Inspect all the connections data bus powertrain, implausible message of the awd control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns