VW Code 13465
13465 Description And Summary : |
---|
Diagnosing engine bar with load signal stuck on to change the oil filter and use the recommended engine oil to avoid any problems in the future so hydraulic pressure sensor 2 adaptation at limit or ignition switch accessory position, circuit will delay your vw fault. |
13465 Possible Causes:
13465 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 13465 Code
- Inspect all the connections fuel additive control module requested mil illumination
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns