VW Code 13462
13462 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust bank 4, sensor 2, tension too largely the system depends on oil pressure to switch between cam profiles oxygen (lambda) sensor b2 s2, signal shorted to heater circuit and wait then fuel pump "b" control, circuit / open will delay your vw fault. |
13462 Possible Causes:
13462 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cold Start Injector 1 Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 13462 Code
- Inspect all the connections exhaust gas temperature sensor, bank 2 sensor 5, circuit intermittent / erratic
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns