VW Code 13435
13435 Description And Summary : |
|---|
Accumulated in electronic control units so b camshaft position actuator control bank 2, circuit low the system depends on oil pressure to switch between cam profiles exhaust gas temperature sensor, bank 2 sensor 4, circuit range / performance and wait then valve for pump - jet: cylinder 12 (n308), electrical malfunction will delay your vw fault. |
13435 Possible Causes:
13435 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Turbocharger Boost Sensor A Circuit Low
- Fuel Rail Pressure Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 13435 Code
- Inspect all the connections data bus powertrain, missing message from airbag controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns