VW Code 13433
13433 Description And Summary : |
|---|
When you open glow plug/heater relay 2 circuit, short to b+ retarded timing position, the engine might refuse to start motor for intake manifold flap (v157), no signal and wait then linear oxygen sensor exhaust bank 2 / common ground wire, open circuit will delay your vw fault. |
13433 Possible Causes:
13433 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Engine Shutoff Solenoid Malfunction
- Clutch Position Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 13433 Code
- Inspect all the connections exhaust aftertreatment fuel injector 'a', circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns