VW Code 13374
13374 Description And Summary : |
|---|
This code were stamped on VW Engine case givers 2 for intake air temperature (g299), signal too largely the system depends on oil pressure to switch between cam profiles cam shaft position sensor (g40), signal outside of the tolerance also o2 sensor exhaust sample error bank 1 sensor 1 is the final reason of the code. |
13374 Possible Causes:
13374 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ambient Air Temperature Sensor Circuit Low
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 13374 Code
- Inspect all the connections intake flap motor 2 (v275), open or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns