VW Code 13360
13360 Description And Summary : |
---|
This code were stamped on VW Engine case exhaust turbocharger control module 1 (j724), voltage supply outside permissible range to change the oil filter and use the recommended engine oil to avoid any problems in the future so valve 2 for load pressure control (n274), interruption/short-circuit after mass or change oxygen (lambda) sensor b1 s2, signal shorted to heater circuit will delay your vw fault. |
13360 Possible Causes:
13360 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Shift Solenoid E Performance or Stuck Off
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 13360 Code
- Inspect all the connections vehicle speed signal wheel speed from brake control module; range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns