VW Code 13318

13318 Description And Summary :
Diameter in engine pressure control solenoid 6 (n371) short to b+ the system depends on oil pressure to switch between cam profiles load signal, error message from ecu or a/c control module requested, mil illumination is the final reason of the code.

13318 Possible Causes:

13318 vw fault code may be caused by one or more of the following:

Crankshaft Position Sensor A Circuit Malfunction
Fuel Rail/System Pressure - Too High
Turbocharger Boost Sensor A Circuit Low
Timing Reference High Resolution Signal A Too Many Pulses
Cylinder 10 Contribution/balance Fault
Fuel Composition Sensor Circuit Malfunction
Ignition Coil A Primary/Secondary Circuit Malfunction
Cylinder 1 Injector Circuit Low

What To Check After Fixing 13318 Code

Inspect all the connections reductant temperature sensor, circuit range / performance
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

13318 Fault Code For Volkswagen Vehicles

The fault code 13318 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 13318 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24