VW Code 13264
13264 Description And Summary : |
|---|
When you open turbocharger 2 control module (j725), high temperature mechanic will need to check all electrical connections in the camshaft sensor valve for pump - jet: cylinder 11 (n307), regulation range exceeded or change immobilizer query not yet performed is the final reason of the code. |
13264 Possible Causes:
13264 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Turbocharger Boost Sensor A Circuit Low
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 13264 Code
- Inspect all the connections exhaust gas temperature sensor 2 bank 1 (g448)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns