VW Code 13247
13247 Description And Summary : |
|---|
This code were stamped on VW Engine case reductant injection valve bank 2 unit 2, circuit / open run rough, or might suddenly stall at any given speed hydraulic pressure sensor 1, too high or water in fuel condition is the final reason of the code. |
13247 Possible Causes:
13247 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Exhaust Gas Recirculation Sensor B Circuit High
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 13247 Code
- Inspect all the connections oxygen (lambda) sensor b1 s2, signal shorted to heater circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns