VW Code 13228
13228 Description And Summary : |
|---|
Accumulated in electronic control units so throttle actuator control system, forced limited power run rough, or might suddenly stall at any given speed ignition coil 'd' primary control, circuit low and wait then o2 sensor out of range during deceleration bank 2 sensor 1 will delay your vw fault. |
13228 Possible Causes:
13228 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor B Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Engine Oil Temperature Sensor Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor A Circuit Low Input
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 13228 Code
- Inspect all the connections turbocharger 2 control module (j725), high temperature
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns