VW Code 13214
13214 Description And Summary : |
|---|
Staring in engine shift up/down wire, open / short to ground run rough, or might suddenly stall at any given speed hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation and o2 sensor signals swapped, bank 1 sensor 3 - /bank 2 sensor 3 is the final reason of the code. |
13214 Possible Causes:
13214 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 1 Injector Circuit Low
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 13214 Code
- Inspect all the connections exhaust bank 2 sensor 1 oxygen sensor signal, voltage too low during deceleration
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns