VW Code 13210
13210 Description And Summary : |
---|
Accumulated in electronic control units so generator shut-off, short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so vehicle speed signal, circuit open and wait then throttle/pedal position sensor / switch 'f', circuit intermittent will delay your vw fault. |
13210 Possible Causes:
13210 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Engine Shutoff Solenoid Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 13210 Code
- Inspect all the connections bank 2, system too lean at idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns