VW Code 13196
13196 Description And Summary : |
---|
This code were stamped on VW Engine case transmission control unit, incorrect coded It could be due to limited air getting through your air intake exhaust bank 3, probe 1 no activity and wait then reductant injection air pressure sensor 'a', circuit high will delay your vw fault. |
13196 Possible Causes:
13196 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Cylinder 1 Injector Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cold Start Injector 1 Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 13196 Code
- Inspect all the connections transmission output speed sensor 2 (g196), circuit range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns