logo

VW Code 13147

13147 Description And Summary :

This something to do with the intake camshaft timing hydraulic actuator position sender (g302), electrical malfunction in circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so givers 2 for intake air temperature (g299), signal too small you can see the valve for exhaust flap 1 (n321), short to ground will delay your vw fault.

13147 Possible Causes:

13147 vw fault code may be caused by one or more of the following:

  • Reverse Input Circuit
  • Manifold Absolute Pressure/Barometric Pressure Circuit High Input
  • Fuel Rail Pressure Sensor Circuit Malfunction
  • Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
  • Glow Plug/Heater Circuit 'A' Malfunction
  • Injector Circuit Malfunction - Cylinders
  • Ignition Coil A Primary/Secondary Circuit Malfunction
  • Cylinder 10 Contribution/balance Fault

What To Check After Fixing 13147 Code

  • Inspect all the connections activation, intake manifold runner bank 2 control, range / performance
  • Check the engine oil to ensure it's clean and the viscosity
  • Restart the vehicle and retest to see if the error returns

VW 001 - 196 Code Range

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range