VW Code 13136
13136 Description And Summary : |
|---|
When you open control unit programming, programming not finished It could be due to limited air getting through your air intake fuel injector group 'c' supply voltage, circuit high or change motor for intake manifold flap (v157), no signal is the final reason of the code. |
13136 Possible Causes:
13136 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Engine Oil Temperature Sensor Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 13136 Code
- Inspect all the connections fuel injector group 'd' supply voltage, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns