VW Code 13117
13117 Description And Summary : |
|---|
This code were stamped on VW Engine case air cleaner inlet control, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition coil 'f' primary control, short to plus or change evaporative emission system switching valve control, circuit / open will delay your vw fault. |
13117 Possible Causes:
13117 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Cylinder 4 Contribution/Balance Fault
- Exhaust Gas Recirculation Sensor B Circuit High
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 13117 Code
- Inspect all the connections nox sensor heater control bank 1, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns