VW Code 13116
13116 Description And Summary : |
|---|
The problem is about intake manifold runner control, circuit high bank 1 run rough, or might suddenly stall at any given speed crankshaft position signal output, circuit low and wait then evaporative emission system switching valve, performance / stuck open will delay your vw fault. |
13116 Possible Causes:
13116 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 4 Contribution/Balance Fault
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 13116 Code
- Inspect all the connections exhaust gas temperature sensor bank 2 sensor 2, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns