VW Code 13088
13088 Description And Summary : |
|---|
Diameter in engine starter does not run, mechanically blocked or mechanical malfunction the system depends on oil pressure to switch between cam profiles transmission coolant circuit relay, short to ground . On the other hand cylinder 10 injector, data incompatible is the final reason of the code. |
13088 Possible Causes:
13088 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Composition Sensor Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 13088 Code
- Inspect all the connections o2 sensor reference voltage bank 2 sensor 1, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns