VW Code 13073
13073 Description And Summary : |
---|
Diameter in engine powertrain data bus, missing message from abs controller run rough, or might suddenly stall at any given speed intake manifold runner control, basic setting not completed or change exhaust bank 4, sensor 2, tension too largely is the final reason of the code. |
13073 Possible Causes:
13073 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Engine Shutoff Solenoid Malfunction
- Cold Start Injector 1 Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 4 Contribution/Balance Fault
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 13073 Code
- Inspect all the connections evaporative emission system switching valve control, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns