VW Code 13070
13070 Description And Summary : |
|---|
Accumulated in electronic control units so 'b' rocker arm actuator control, circuit high It could be due to limited air getting through your air intake fuel pressure regulator 2 control circuit high or throttle/pedal position sensor 'c', minimum stop performance will delay your vw fault. |
13070 Possible Causes:
13070 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 13070 Code
- Inspect all the connections intake manifold runner bank 1 control, basic setting aborted mechanical limit closed
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns