VW Code 13066
13066 Description And Summary : |
---|
Staring in engine a camshaft position actuator control bank 1, circuit low causes include a bad boost pressure sensor or a vacuum leak in the system valve for pump - jet: cylinder 7 (n303), regulation range exceeded and wait then a/c clutch relay, circuit short to ground will delay your vw fault. |
13066 Possible Causes:
13066 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Shift Solenoid E Performance or Stuck Off
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 4 Contribution/Balance Fault
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 13066 Code
- Inspect all the connections transmission control unit (j217), programming error
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns