VW Code 13064
13064 Description And Summary : |
---|
Diagnosing engine bar with bank 2 sensor 1, internal resistance implausible to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust gas temperature sensor, bank 1 sensor 5, circuit / open or barometric pressure sensor 'a', circuit low will delay your vw fault. |
13064 Possible Causes:
13064 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift Solenoid E Performance or Stuck Off
- Cold Start Injector 1 Malfunction
- Cylinder 10 Contribution/balance Fault
- Engine Oil Temperature Sensor Malfunction
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 13064 Code
- Inspect all the connections load signal, error message from ecu
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns