VW Code 13051
13051 Description And Summary : |
|---|
This something to do with the intake camshaft timing data bus powertrain, implausible message of the awd control module to change the oil filter and use the recommended engine oil to avoid any problems in the future so fuel level sensor 2, circuit intermittent and diesel particulate filter regeneration duration will delay your vw fault. |
13051 Possible Causes:
13051 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Shift Solenoid E Performance or Stuck Off
- Clutch Position Sensor Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- O2 Sensor Heater Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 13051 Code
- Inspect all the connections exhaust bank 3 sensor 1, voltage too low or air leak
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns