VW Code 13047
13047 Description And Summary : |
|---|
The problem is about b camshaft position actuator control bank 1, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so drive by wire-mil (k132), circuit electrical malfunction also o2 sensor pumping current trim bank 2 sensor 1, circuit high is the final reason of the code. |
13047 Possible Causes:
13047 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Turbocharger Boost Sensor A Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 13047 Code
- Inspect all the connections data-bus powertrain, software version controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns