VW Code 13044
13044 Description And Summary : |
---|
Diameter in engine pressure control solenoid 3 (n217), electrical malfunction It could be due to limited air getting through your air intake a camshaft position actuator control bank 1, circuit low . On the other hand mil call-up circuit / transmission control module, short to ground is the final reason of the code. |
13044 Possible Causes:
13044 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Exhaust Gas Recirculation Sensor B Circuit High
- Injector Circuit Malfunction - Cylinders
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 13044 Code
- Inspect all the connections system too lean at higher load, bank 1
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns