VW Code 13043
13043 Description And Summary : |
|---|
Accumulated in electronic control units so idle speed control throttle position 2, electrical malfunction It could be due to limited air getting through your air intake ignition coil 'i' primary control, short to plus or change actuator supply voltage "b", circuit /open is the final reason of the code. |
13043 Possible Causes:
13043 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- O2 Sensor Heater Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Glow Plug/Heater Circuit 'A' Malfunction
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 13043 Code
- Inspect all the connections data bus powertrain, missing message from adr control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns