VW Code 13035
13035 Description And Summary : |
---|
Diameter in engine internal control module: eeprom error It could be due to limited air getting through your air intake intake manifold runner control: open stop outside of valid range also ecm/pcm power relay sense, circuit range / performance will delay your vw fault. |
13035 Possible Causes:
13035 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Cylinder 10 Contribution/balance Fault
- Turbocharger Boost Sensor A Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 13035 Code
- Inspect all the connections camshaft adjustment oil temperature sensor (g277), open or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns