VW Code 13031
13031 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition coil 'j' primary control, short to plus to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust gas temperature bank 2, too high or power supply (b+) terminal 15, low voltage is the final reason of the code. |
13031 Possible Causes:
13031 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Temperature Sensor B Circuit Range/Performance
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Glow Plug/Heater Circuit 'A' Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 13031 Code
- Inspect all the connections linear oxygen sensor exhaust bank 3 / common ground wire, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns