VW Code 13019
13019 Description And Summary : |
|---|
Diagnosing engine bar with automatic glow time control module 2 (j609), circuit implausible signal causes include a bad boost pressure sensor or a vacuum leak in the system transmission mount valve 2 (n263), short to b+ . On the other hand bank 2, cam shaft position sensor, discharge opening (g301), short-circuit to mass will delay your vw fault. |
13019 Possible Causes:
13019 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 1 Injector Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 13019 Code
- Inspect all the connections evaporative emission system vent (n115), valve stuck closed
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns