VW Code 13016
13016 Description And Summary : |
---|
This code were stamped on VW Engine case o2 sensor out of range during deceleration bank 1 sensor 1 to change the oil filter and use the recommended engine oil to avoid any problems in the future so fuel pump "b" control, circuit / open and wait then actuator supply voltage "b", circuit high will delay your vw fault. |
13016 Possible Causes:
13016 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor A Circuit Low Input
- Crankshaft Position Sensor A Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 13016 Code
- Inspect all the connections secondary air injection pump-c-relay (j704), circuit short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns