VW Code 13006
13006 Description And Summary : |
|---|
This code were stamped on VW Engine case leak in air intake system the system depends on oil pressure to switch between cam profiles turbocharger control module 2, implausible message and wait then ignition coil 'k' primary control, short to plus will delay your vw fault. |
13006 Possible Causes:
13006 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 13006 Code
- Inspect all the connections catalyst system exhaust bank 4, effectiveness too low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns