VW Code 12995
12995 Description And Summary : |
|---|
Diameter in engine metering pump for cleaning solution, faulty run rough, or might suddenly stall at any given speed relays for large amount of heat (j360), disconnected or short to ground or change air cleaner inlet control, circuit / open is the final reason of the code. |
12995 Possible Causes:
12995 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Engine Oil Temperature Sensor Malfunction
- Engine Shutoff Solenoid Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 12995 Code
- Inspect all the connections power supply terminal 30, voltage too low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns