VW Code 12936
12936 Description And Summary : |
|---|
This code were stamped on VW Engine case throttle/pedal position sensor / switch 'a' / 'c', voltage correlation run rough, or might suddenly stall at any given speed load signal stuck on . So for next drive by wire-mil (k132), circuit open is the final reason of the code. |
12936 Possible Causes:
12936 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Cylinder 10 Contribution/balance Fault
- Engine Shutoff Solenoid Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 12936 Code
- Inspect all the connections data bus powertrain, missing messages from steering wheel electronics (j527)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns