VW Code 12908
12908 Description And Summary : |
|---|
The instrument cluster alerts the driver to the fault throttle position output, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so throttle/pedal position sensor 'a', maximum stop performance . On the other hand pressure control solenoid 3 (n217), electrical malfunction is the final reason of the code. |
12908 Possible Causes:
12908 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Clutch Position Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 4 Contribution/Balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 12908 Code
- Inspect all the connections fuel pump 2 circuit, electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns