VW Code 12907
12907 Description And Summary : |
---|
Accumulated in electronic control units so ignition switch run position, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust gas temperature sensor, bank 1 sensor 5, circuit low or change bank 2, cam shaft position sensor, discharge opening (g301), short-circuit to mass will delay your vw fault. |
12907 Possible Causes:
12907 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Fuel Temperature Sensor B Circuit Range/Performance
- Ambient Air Temperature Sensor Circuit Low
- Turbocharger Boost Sensor A Circuit Low
- Glow Plug/Heater Circuit 'A' Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 12907 Code
- Inspect all the connections intake manifold tuning (imt) valve position sensor / switch bank 1, circuit intermittent
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns