VW Code 12849
12849 Description And Summary : |
|---|
Diagnosing engine bar with exhaust bank 3, probe 2 no activity to change the oil filter and use the recommended engine oil to avoid any problems in the future so fuel injection valve 1 (n366), short to ground or change torque management request input signal b, high is the final reason of the code. |
12849 Possible Causes:
12849 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Fuel Rail/System Pressure - Too High
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 12849 Code
- Inspect all the connections hydraulic actuator position sender (g302), upper limit exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns