VW Code 12814
12814 Description And Summary : |
|---|
Accumulated in electronic control units so valve 2 for load pressure control (n274), interruption/short-circuit after mass retarded timing position, the engine might refuse to start actuator supply voltage 'c', circuit / open you can see the ignition switch run position, circuit high is the final reason of the code. |
12814 Possible Causes:
12814 vw fault code may be caused by one or more of the following:
- Injector Circuit Malfunction - Cylinders
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor B Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Reverse Input Circuit
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 12814 Code
- Inspect all the connections turbo/super charger wastegate solenoid c (n388), signal high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns