VW Code 12746
12746 Description And Summary : |
|---|
When you open ecm/pcm power input, signal to change the oil filter and use the recommended engine oil to avoid any problems in the future so linear oxygen sensor exhaust bank 1, compensation wire pump current, open circuit also throttle/pedal position sensor 'e', minimum stop performance will delay your vw fault. |
12746 Possible Causes:
12746 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 12746 Code
- Inspect all the connections valve for pump - jet, cylinder 6 (n245), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns