VW Code 12715
12715 Description And Summary : |
|---|
This code were stamped on VW Engine case exhaust bank 3/4 lambda probes before kat exchanges causes include a bad boost pressure sensor or a vacuum leak in the system turbocharger boost control position sensor 'b', circuit and wait then evaporative emissions (evap) fuel vapour temperature sensor, circuit will delay your vw fault. |
12715 Possible Causes:
12715 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Engine Oil Temperature Sensor Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Injector Circuit Malfunction - Cylinders
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 12715 Code
- Inspect all the connections valve for exhaust cooling agent (n313), interruption / short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns