VW Code 12711
12711 Description And Summary : |
|---|
The problem is about diesel particulate filter pressure sensor 'a', circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust bank 4, sensor 2 heater circuit, electrical error and exhaust bank 4, sensor 2, signal too slowly will delay your vw fault. |
12711 Possible Causes:
12711 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Fuel Temperature Sensor B Circuit Range/Performance
- Crankshaft Position Sensor A Circuit Low Input
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 12711 Code
- Inspect all the connections kick down switch malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns