VW Code 12698
12698 Description And Summary : |
|---|
The problem is about exhaust gas temperature sensor, bank 2 sensor 4, circuit high retarded timing position, the engine might refuse to start bank 2, cam shaft position sensor, discharge opening (g301), interruption / short-circuit to pluses . So for next evaporative emissions (evap) fuel vapour temperature sensor, performance will delay your vw fault. |
12698 Possible Causes:
12698 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 12698 Code
- Inspect all the connections cylinder 6 injector, data incompatible
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns