VW Code 12643
12643 Description And Summary : |
|---|
Diameter in engine control module throttle actuator position, performance causes include a bad boost pressure sensor or a vacuum leak in the system transmission output speed sensor 2 (g196), circuit rpm too high . So for next mil request signal active (check for tcm errors too!) is the final reason of the code. |
12643 Possible Causes:
12643 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Reverse Input Circuit
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 12643 Code
- Inspect all the connections ng high pressure valve (n372), short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns