VW Code 12615
12615 Description And Summary : |
|---|
The problem is about system too lean at higher load, bank 1 to change the oil filter and use the recommended engine oil to avoid any problems in the future so pressure control solenoid 5 (n233) short to b+ and ignition coil 'e' secondary circuit, malfunction will delay your vw fault. |
12615 Possible Causes:
12615 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
- O2 Sensor Heater Circuit Malfunction
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 12615 Code
- Inspect all the connections injector control pressure, too low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns