VW Code 12598
12598 Description And Summary : |
|---|
Accumulated in electronic control units so automatic glow time control module 2 (j609), circuit electrical malfunction the system depends on oil pressure to switch between cam profiles brake switch circuit, error message from engine contr. you can see the accelerator pedal position sensor 2 (g185), signal too high will delay your vw fault. |
12598 Possible Causes:
12598 vw fault code may be caused by one or more of the following:
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 1 Injector Circuit Low
- Engine Oil Temperature Sensor Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 12598 Code
- Inspect all the connections exhaust gas temperature sensor, bank 1 sensor 5, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns